Sondeen
01-25-2008, 10:56 AM
I have a slightly used clamp expander for those C-clamps that hold the Exhaust Pipe (Header Pipe) to the Engine Exhaust Manifold on A1 and early A2s (RV engine) .
It was Manufactured by Charles Meglio, LLC, you can see the details about the tool here:
http://www.metalnerd.com/cat08.htm
It is Part MN406600.
It works just as well as they say, it makes taking those springs on and off easy and safe. It has been used to do one exhuast job, and it is unlikely I will need it again in the next 7 years. So I figure I would offer it too someone who may be able to use it for less than a new one.
I paid $65 plus shipping. I am asking $35.00, plus actual shipping cost. Can ship USPS or UPS.
It was Manufactured by Charles Meglio, LLC, you can see the details about the tool here:
http://www.metalnerd.com/cat08.htm
It is Part MN406600.
It works just as well as they say, it makes taking those springs on and off easy and safe. It has been used to do one exhuast job, and it is unlikely I will need it again in the next 7 years. So I figure I would offer it too someone who may be able to use it for less than a new one.
I paid $65 plus shipping. I am asking $35.00, plus actual shipping cost. Can ship USPS or UPS.